AED70: A Wand Holder

A continuation of yesterday’s 3D modeling for my remote control!

This took a disgustingly long amount of time, especially considering all I was trying to do was to chop up an STL.


After cutting it in half, I made some connection pieces – there’s a hole in the other base piece, and sent it to the printer…


Where I realized my printer is too small to print the bottom piece, so I had to cut it into 3 pieces instead of 2. I had to remove the connection piece, reconnect the two, and then cut it and add connection pieces again.Capture3

Once I finally got everything saved as STL files, we’re off to printing!



AED69: A Wand Holder!


I needed something to hold the remote control wand. Pretend the little cactuses don’t look like cactuses. It looks pretty simple, but this actually took a while to make because my 3D modeling skills are close to none. Tomorrow I’m going to attempt to cut it in half and hopefully start to print!