A continuation of yesterday’s 3D modeling for my remote control!
This took a disgustingly long amount of time, especially considering all I was trying to do was to chop up an STL.
After cutting it in half, I made some connection pieces – there’s a hole in the other base piece, and sent it to the printer…
Where I realized my printer is too small to print the bottom piece, so I had to cut it into 3 pieces instead of 2. I had to remove the connection piece, reconnect the two, and then cut it and add connection pieces again.
Once I finally got everything saved as STL files, we’re off to printing!
Advertisements
